ok guys i drive an 03 civic ex. i did an auto to manual swap. and everythiing went perfect, except my car want start unless i have a code reader or scan tool plugged in my DLC (data link connector). well i still have my auto dash / ecu harness with the the two wires ground under the driver side fuse box so the car will start. and im useing an 02 ex ecu, and an 01 civic engine harness. but on the engine harness i spiled the connecter that goes to the ecu harnees withe an auto connector b/c its the same wires. so i need to no where i went wrong to get my car to start without something plugged in the DLC. im thinking the auto connector has wires in different pins. just tell me what guys think i should do. thanks. i really need to get my car inspected and and it want start with the state cp connector in it.