Honda Civic Forums - 7thGenHonda banner
torque
1-10 of 12 Results
  1. Mechanical Problems
    I broke one of the bolts that hold the rocker arms down, can I reuse the others or should I get all new ones while I am at it? Also, does anyone have the torque ratings for those? Hayes said 136 but one snapped when I had it set at 110.
  2. For Sale/Trade
    Bought off another member but never got around to install it. Looking to get my money back. Comes with everything needed to install including instructions. **SOLD**
  3. Suspension
    Ok before i begin please do not flood my thread with "lower tie bar dont do shit except looks" "your newb negative 1point for you" lol I know the lower tie bar doesn't do anything without all other suspension components, but i got one for free and the look is dmn nice under there.Thanks for help...
  4. Engine & Transmission
    Valve Specs-Cold Engine Intake-0.18-0.22 mm (0.007-0.009 in.) Exhaust-0.23-0.27 mm (0.009-0.011 in.) Valve Cover Torque Specs and Torque Diagram 7.2 ft.lbs Cylinder Head Torque Specs and Torque Diagram Tighten the cylinder head bolts sequentially in three steps. 1st Step Torque...
  5. Suspension
    about a month ago now i got t-boned comin out of the parkin lot @ school and got the car fixed cuz i wasnt at fault. they replaced my right front strut assembly because it was damaged in the crash. the last week or so since i got it back ive noticed that around 6k rpm i start torque steering to...
  6. Off-Topic
    I need to buy a good Torque Wrench when I get back. Anybody have any recomendations? personal favorites? Are the electronic torque wrenches any good, or should I just stick with a normal wrench? Thanks
  7. General Talk
    Is there a thread with the torque specs of the engine bay in this forum already? If so where. I have a really bad headache and i dont wanna use "THE SEARCH" button
  8. Basic Performance
    bought it for 150 shipped from corsport. great service by the way. got it a few days later. opened it up and it was all shiny and new. its been about a month and i finally got it installed. knee surgery not lazy. I started at 12am and finished by 1 am. took it for a test drive and all i can say...
  9. Mechanical Problems
    Mine just went out right after i swapped a new d17 in w/ the old trans.. Is this sumthing that can just happen unrelated to the swap or.. was it the swap? And what exactly does this solenoid do?
  10. Basic Performance
    what are the torque specs for the 7 bolts? 2 bolts at the cat 3 bolts at the midpipe 2 bolts at the muffler
1-10 of 12 Results
Top