Honda Civic Forums - 7thGenHonda banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results
  1. Engine & Transmission
    Remove the flange bolts. Remove the sealing cap using a 1/2" extension Expand the snap ring on the counter shaft bearing while prying the housing open The housing might be stuck to the dowel pins do not scratch the mating surfacing separate gently.
  2. Engine & Transmission
    Remove trans (see DIY in engines and transmissions) Remove (2) detent bolts, (2)springs, (2)balls and backup light switch Remove the selector lever assembly. Put it in the center position which is neutral
  3. Engine & Transmission
    Raise vehicle. Support on jack stands. Chock wheels. Apply parking brake. Remove left and right axle nuts (32mm). Remove cotter pin from lower balljoint. Remove 17mm nut holding balljoint. Place a jack under the lower control arm. Raise the jack until their is enough space to insert a 1/2...
1-3 of 3 Results